Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
orbiter:
--- Quote from: marmad on June 05, 2013, 12:34:54 pm ---
--- Quote from: XaS on June 05, 2013, 12:15:29 pm ---- Select Period Measurement on CH1. I would like it to appear on the right of Period Measurement CH2, like this:
| Period CH2 | Period CH1 | empty | empty | empty |
Instead I get the same as after the first step. I see no way to sort the measurements the way I like besides fill all measurement slots with garbage, delete them and then fill them in the right order.
--- End quote ---
Hmm... I get exactly what you would like to get (as shown above) - I don't get the same as after the first step ???
For me, the Recover options don't seem to have any effect if I've used 'All Items' -> 'Delete'.
--- End quote ---
I get the same as marmad too.
XaS:
marmad and orbiter, thanks for checking with your units. I still run v00.00.01.00.05, maybe this is fixed in the most recent software version?
XaS
Jean:
I have the same behaviour as XaS :
- clear all
- period on ch1 then ch2 => period period
- clear all
- period on ch2 then ch1 => period period
Firmware 00.00.01.00.05
Jean:
--- Quote from: ct on June 05, 2013, 12:00:55 pm ---I start following this topic after I watched Marmad's review of the Rigol 2072 oscilloscope. ...And here is another new owner of the Rigol 2072. I'm a beginner in electronics, with some ties in the past, but I'm very excited to have just bought a tool I can use to see what's going on inside my or others' electronic circuits. And what a tool it is! Also, it's good to see experienced users exploring the features and sharing information about this oscilloscope. For us, beginners, it's priceless. Thanks.
OK, too much excitement here. I'm going back to work now, but I can't wait to use the oscilloscope again.
--- End quote ---
Welcome and enjoy the scope :)
marmad:
--- Quote from: XaS on June 05, 2013, 12:41:31 pm ---marmad and orbiter, thanks for checking with your units. I still run v00.00.01.00.05, maybe this is fixed in the most recent software version?
XaS
--- End quote ---
Yes, I think it must be; I'm using FW 01.00.00.03. What about you, orbiter?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version