| Products > Test Equipment |
| REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol |
| << < (255/566) > >> |
| alank2:
TE says they will ship out on Monday. |
| Corporate666:
--- Quote from: bluesmoke on June 28, 2013, 08:06:03 pm ---Big question is..... Do you still have trial options? --- End quote --- I do. Well, I haven't used them, but upon bootup, I get a screen showing "installed options" and I have several listed under Trigger and a few decode options listed too (RS232, SPI, etc). They all list 2126 minutes left (I think they've counted down a few minutes). When I click System Info, I get software version 00.01.00 and hardware version 1.0. I know (think) there is an extra byte on the end of the software version that I have to do some button pushing to see? I just haven't had time to do much else other than power it up and play with a couple of the features. I have a couple of PCB's I'm trying to get over to the board house this weekend and some machining to do, so just a bit busy. If someone can tell a lazy SOB like me what to do in order to see any full firmware version or if there's anything anyone wants to know about my 'scope, let me know and I will do it and post up. |
| Yaksaredabomb:
--- Quote from: dr.diesel on June 25, 2013, 05:50:59 pm --- --- Quote from: Marc M. on June 25, 2013, 02:54:21 pm ---If one of the members here would be kind enough to PM me the EEV discount code I would be very grateful. --- End quote --- I don't believe there is a code, it's done on a case by case basis. The stuff I've bought via EEV was a hard quote each time with no discount code. --- End quote --- Just wanted to throw a link out to this thread quick in case anyone is still looking for the Tequipment.net code: Special Price FOR EEVblog Members |
| marmad:
--- Quote from: Corporate666 on June 28, 2013, 08:39:05 pm ---If someone can tell a lazy SOB like me what to do in order to see any full firmware version or if there's anything anyone wants to know about my 'scope, let me know and I will do it and post up. --- End quote --- It's all listed in the third post of this thread (down near the bottom). If the DSO came from back inventory, I'm guessing you'll have FW 01.00.02 or 01.00.05. |
| Corporate666:
--- Quote from: marmad on June 28, 2013, 10:37:13 pm --- --- Quote from: Corporate666 on June 28, 2013, 08:39:05 pm ---If someone can tell a lazy SOB like me what to do in order to see any full firmware version or if there's anything anyone wants to know about my 'scope, let me know and I will do it and post up. --- End quote --- It's all listed in the third post of this thread (down near the bottom). If the DSO came from back inventory, I'm guessing you'll have FW 01.00.02 or 01.00.05. --- End quote --- I can't get that to work. I am in the trigger menu w/Edge selected and I'm hitting 7/6/7/Utility quickly (tried to do it all within 1/2 second - also tried to do it slower and more deliberately), and I have key beep turned on, so I know I am getting the key presses. It beeps on 7/6/7 and on Utility it brings up the Utility menu. Anything else that needs to be set - like channels off, in single/run/stop or something? |
| Navigation |
| Message Index |
| Next page |
| Previous page |