Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
Carrington:
CodyShaw:
Nothing bad, I'm just kidding, my apologies. :)
In my DS2072 the fan is quite noisy (loud). But here the temperature is 30 ° C, perhaps the fan is regulated by temperature (fast).
"Let the future tell the truth ...
Carrington:
--- Quote from: marmad on July 17, 2013, 09:52:48 pm ---That upper table is nonsense - Kiriakos didn't use the correct measuring equipment for measuring < 50ns - he claims the DSO is much faster than even Instek claims it is. ;D
You can see the real wfrm/s @ <50ns in Grego's video when he uses a Picoscope to measure the frequency.
--- End quote ---
Grego's video (See at ~ 12 min):
CodyShaw:
--- Quote from: Carrington on July 17, 2013, 11:23:55 pm ---CodyShaw:
Nothing bad, I'm just kidding, my apologies. :)
In my DS2072 the fan is quite noisy (loud). But here the temperature is 30 ° C, perhaps the fan is regulated by temperature (fast).
"Let the future tell the truth ...
--- End quote ---
Thought so! :-DD
Mine is noticeable, but not loud. Cold basement (24 degrees or so)?
CodyShaw:
Sorry, I didn't check my FW correctly...
Actual:
SW: 00.00.01.00.05
HW: 1.0.1.0.0
UberSteve:
Hi All!
New DS2072 owner here! Unit arrived today from Emona Aus. Unit is apparently new stock just arrived from China and reports the following info in the System Information screen:
Serial: DS2A15270XXXX
Software version: 00.01.01.00.02 (latest I believe?)
Hardware version: 1.0.1.0.0
FPGA version:
SPU 03.01.05
WPU 00.06.05
CCU 12.29.00
MCU 00.05
Huge step up from my Bitscope... :D
Thanks to all that have contributed to this thread, it's the main reason I decided on the DS2000. :-+
-Steve
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version