Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
tlu:
When you said 200M+300M do you mean you are able to set the bandwidth limit for this? I thought the latest code dshh will give you 300Mhz but the bandwidth limit selectable were only 20Mhz and 100Mhz. Correct me if I'm wrong.
Teneyes:
--- Quote from: dschnell on December 14, 2013, 09:06:14 pm ---
Anything special I should examine a used scope for ?
--- End quote ---
Hi Dschnell, welcome to this group
check out new posting:
https://www.eevblog.com/forum/testgear/rigol-ds2000-failures-and-rma-reports/msg347926/#msg347926
PA0PBZ:
--- Quote from: tlu on December 15, 2013, 07:19:35 am ---When you said 200M+300M do you mean you are able to set the bandwidth limit for this?
--- End quote ---
No, if you go from DS2072 to DS2202 the options screen shows the 200 Mhz bandwidth. If you then update to the newest fw and apply the DS2302 code you end up with both 200 Mhz and 300 Mhz in the options screen. I don't think it is a problem though.
nack:
I have had the same issue with both the 200MHz and 300MHz option available in the options menu. Didn't like it, so I uninstalled the options altogether and entered the 300MHz (+CAN options) to be sure.
dschnell:
--- Quote from: PA0PBZ on December 15, 2013, 12:07:38 pm ---
--- Quote from: tlu on December 15, 2013, 07:19:35 am ---When you said 200M+300M do you mean you are able to set the bandwidth limit for this?
--- End quote ---
No, if you go from DS2072 to DS2202 the options screen shows the 200 Mhz bandwidth. If you then update to the newest fw and apply the DS2302 code you end up with both 200 Mhz and 300 Mhz in the options screen. I don't think it is a problem though.
--- End quote ---
That is exactly what I meant. I have both options installed at the same time: the 200MHz and the 300MHz option. The channel bandwidth limit shows 20M and 100M as for all others.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version