Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
<< < (389/566) > >>
flolic:

--- Quote from: NikWing on December 21, 2013, 12:21:46 pm ---
yes, I meant the horizontal width of the curve ... on my old DSO I saw a thin line, here I see lotsa noise when I decrease the timebase :o
20 MHz didn't make it better, reduced it only a little bit ...

--- End quote ---


Acquire -> Acquisition ->HighRes
NikWing:
I'll try and see :)
I've used older HP, Philips and new Agilent DSOs before but there's more difference than I expected to be, I really have to get used to it
I've also noticed that the trigger in auto mode doesn't adjust the level as fast as on my old DSO after I changed the V/div value  :o

btw, I saw animated gif screenshots earlier here on this forum.
how were they created? with the rigol software or frame by frame by hand?
EV:
I2C decode has also details in Event table but RS232 and SPI decodes do not.


--- Quote from: Mark_O on December 21, 2013, 07:35:26 am ---Thanks again.  That is interesting, and I've definitely never seen it before.

--- End quote ---
marmad:

--- Quote from: NikWing on December 21, 2013, 03:01:51 pm ---btw, I saw animated gif screenshots earlier here on this forum.
how were they created? with the rigol software or frame by frame by hand?

--- End quote ---
With the software I wrote: Rigol Ultravision Utilities (RUU) - available in this thread (download link at bottom of first post).  It's especially handy for just getting screen captures from the DSO to the PC in a few seconds - but can also turn recorded frames into animated GIFs or waterfall plots (as well as a bunch of other stuff).

I'm working on a new version now - which will finally allow saving of all file types/sample lengths. Hopefully I'll have it ready within the next couple of weeks...





murdok:
Can somebody confirm following behavior with latest FW on DS2k devices:

1st channel only -> 2GS/s
2nd channel only -> 1GS/s

At least i can't remember reading anything about that.
I expected to have a drop of maximum sample rate from 2GS/s to 1GS/s only in case when both channels are active at once.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod