Products > Test Equipment

REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol

<< < (389/566) > >>

flolic:

--- Quote from: NikWing on December 21, 2013, 12:21:46 pm ---
yes, I meant the horizontal width of the curve ... on my old DSO I saw a thin line, here I see lotsa noise when I decrease the timebase :o
20 MHz didn't make it better, reduced it only a little bit ...

--- End quote ---


Acquire -> Acquisition ->HighRes

NikWing:
I'll try and see :)
I've used older HP, Philips and new Agilent DSOs before but there's more difference than I expected to be, I really have to get used to it
I've also noticed that the trigger in auto mode doesn't adjust the level as fast as on my old DSO after I changed the V/div value  :o

btw, I saw animated gif screenshots earlier here on this forum.
how were they created? with the rigol software or frame by frame by hand?

EV:
I2C decode has also details in Event table but RS232 and SPI decodes do not.


--- Quote from: Mark_O on December 21, 2013, 07:35:26 am ---Thanks again.  That is interesting, and I've definitely never seen it before.

--- End quote ---

marmad:

--- Quote from: NikWing on December 21, 2013, 03:01:51 pm ---btw, I saw animated gif screenshots earlier here on this forum.
how were they created? with the rigol software or frame by frame by hand?

--- End quote ---
With the software I wrote: Rigol Ultravision Utilities (RUU) - available in this thread (download link at bottom of first post).  It's especially handy for just getting screen captures from the DSO to the PC in a few seconds - but can also turn recorded frames into animated GIFs or waterfall plots (as well as a bunch of other stuff).

I'm working on a new version now - which will finally allow saving of all file types/sample lengths. Hopefully I'll have it ready within the next couple of weeks...





murdok:
Can somebody confirm following behavior with latest FW on DS2k devices:

1st channel only -> 2GS/s
2nd channel only -> 1GS/s

At least i can't remember reading anything about that.
I expected to have a drop of maximum sample rate from 2GS/s to 1GS/s only in case when both channels are active at once.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod