Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
alank2:
I don't know if it is a bug or an inconsistency, but in ds2302 mode if you turn the unit off and on and go to change the bandwidth for a channel, it will not open a menu and let you use the spin knob to select it. It will just toggle the setting to the next one. If you restore a saved configuration or default settings, you will get the menu. If you power cycle again, the menu will no longer work and you will be toggling through the options until you restore settings/defaults again. This is on both HW 1.0.1.0.0 and HW 1.0.2.0.2. You always get the menu as expected in ds2202 mode.
PA0PBZ:
Bandwidth DS2302 HW 2, signal generator on 1 volt, 10 Mhz steps:
Carrington:
--- Quote from: PA0PBZ on January 07, 2014, 03:32:37 pm ---Bandwidth DS2302 HW 2, signal generator on 1 volt, 10 Mhz steps:
--- End quote ---
Awesome... :o
alank2:
--- Quote from: PA0PBZ on January 07, 2014, 03:32:37 pm ---Bandwidth DS2302 HW 2, signal generator on 1 volt, 10 Mhz steps:
--- End quote ---
Can you repeat that in DS2202 mode with HW 2?
JDubU:
--- Quote from: PA0PBZ on January 07, 2014, 02:26:33 pm ---And 1nS :palm:
--- End quote ---
Something looks wrong in your screen captures: (https://www.eevblog.com/forum/testgear/first-impressions-and-review-of-the-rigol-ds2072-ds2000-series-dso/msg362905/#msg362905).
How are you getting a continuous trace of closely spaced dots? You should be seeing only one dot per horizontal division (1 ns/div, 1G samples/second).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version