Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
<< < (429/566) > >>
alank2:
While you are reporting bugs, not that I can say this is a bug, when you first power on the unit all lights light up except the CH1 for some reason.  If they are come on as a function test at power up, shouldn't CH1 also light too?
Fagear:

--- Quote from: alank2 on January 08, 2014, 10:11:28 pm ---While you are reporting bugs, not that I can say this is a bug, when you first power on the unit all lights light up except the CH1 for some reason.  If they are come on as a function test at power up, shouldn't CH1 also light too?

--- End quote ---
It flashes for a second but then switches off. I agree - this is strange.

I also have bug with USB stick detection (on both FW 01 and 02).
After power on if I plug USB stick in - oscilloscope doesn't recognise it. In normal mode and when updating FW through Power->Help sequence. I have to unplug USB stick and replug it again and now USB stick is available (message appears on the screen or FW update starts).
Tried two different USB sticks: one old 256 Mb and one new 8 Gb.
Hydrawerk:
Please does DS2000 or DS2000A with latest firmware have cursors in XY mode? According to the latest manual, they are now implemented.  :-+ :-+ http://www.rigol.com/prodserv/DS2000A/document/
Teneyes:

--- Quote from: alank2 on January 08, 2014, 10:11:28 pm ---While you are reporting bugs, not that I can say this is a bug, when you first power on the unit all lights light up except the CH1 for some reason.  If they are come on as a function test at power up, shouldn't CH1 also light too?

--- End quote ---
On My DSO FW 02.01.00.03    HW 1.0.1.0.0
All lights flash once,
and 'RUN/STOP' flashes orange
Now if
         'Help' is pushed the "RUN/STOP" goes Off and the 'SINGLE' stays on
and if
         'F6' left is pushed  the "RUN/STOP" goes Green and the  'SINGLE' goes Off    Immediately
I can see with the Help load FW function;
the need to have 'CH1' go off in order to show when a new Firmware is loading ,
by flashing 'CH1'
marmad:

--- Quote from: Hydrawerk on January 08, 2014, 10:51:27 pm ---Please does DS2000 or DS2000A with latest firmware have cursors in XY mode?

--- End quote ---

Yes, already reported earlier in this thread.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod