Products > Test Equipment

REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol

<< < (429/566) > >>

alank2:
While you are reporting bugs, not that I can say this is a bug, when you first power on the unit all lights light up except the CH1 for some reason.  If they are come on as a function test at power up, shouldn't CH1 also light too?

Fagear:

--- Quote from: alank2 on January 08, 2014, 10:11:28 pm ---While you are reporting bugs, not that I can say this is a bug, when you first power on the unit all lights light up except the CH1 for some reason.  If they are come on as a function test at power up, shouldn't CH1 also light too?

--- End quote ---
It flashes for a second but then switches off. I agree - this is strange.

I also have bug with USB stick detection (on both FW 01 and 02).
After power on if I plug USB stick in - oscilloscope doesn't recognise it. In normal mode and when updating FW through Power->Help sequence. I have to unplug USB stick and replug it again and now USB stick is available (message appears on the screen or FW update starts).
Tried two different USB sticks: one old 256 Mb and one new 8 Gb.

Hydrawerk:
Please does DS2000 or DS2000A with latest firmware have cursors in XY mode? According to the latest manual, they are now implemented.  :-+ :-+ http://www.rigol.com/prodserv/DS2000A/document/

Teneyes:

--- Quote from: alank2 on January 08, 2014, 10:11:28 pm ---While you are reporting bugs, not that I can say this is a bug, when you first power on the unit all lights light up except the CH1 for some reason.  If they are come on as a function test at power up, shouldn't CH1 also light too?

--- End quote ---
On My DSO FW 02.01.00.03    HW 1.0.1.0.0
All lights flash once,
and 'RUN/STOP' flashes orange
Now if
         'Help' is pushed the "RUN/STOP" goes Off and the 'SINGLE' stays on
and if
         'F6' left is pushed  the "RUN/STOP" goes Green and the  'SINGLE' goes Off    Immediately
I can see with the Help load FW function;
the need to have 'CH1' go off in order to show when a new Firmware is loading ,
by flashing 'CH1'

marmad:

--- Quote from: Hydrawerk on January 08, 2014, 10:51:27 pm ---Please does DS2000 or DS2000A with latest firmware have cursors in XY mode?

--- End quote ---

Yes, already reported earlier in this thread.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod