Products > Test Equipment

REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol

<< < (454/566) > >>

gaijin:
yeah my mistake

neslekkim:
Does it exists any youtube channel that teaches how to use the scope?, or any places with good usability writeups?

Say, I tried something simple, to see if there are any overshoot on my psu, I think I somewhat managed to make the trigger to work (voltage) but I couldn't get an detailed view of it.. And when I try to capture an wave, it seems like it captures like 5-7 frames?

gaijin:
it doesn't seem to be limited to 200ms

28Mpts
I see it happening in:
200ms
1s
2s
10s
20s

while these don't seem to have the problem:
500ms
5s
50s

Circlotron:
I have it too.
Move the centre reference to the right and the end of the trace doesn't move as far as the reference.
The trace actually stops scanning. I could see a glitch on the trace where I plugged the USB flash drive in and it never went away.

-> The problem does not seem to occur in hi-res mode, only normal and peak detect. <-

luchog:
Hello:

When decode zoomed data in SPI mode, the bus status is shifted respect waveforms.
The sample picture was captured in 1mS scale and zoomend to 100.0nS.
DS2202, [FW v.02.01.00.03]

Can someone verify this?

Settings:
SCLK:
Channel: 2
Slope: Rissing.
Threshold 1.92V
SDA:
Channel: 1
Polarity: _|1|_
Threshold 1.9V

Timeout: 87.0nS
Data Bits: 8
Endian: MSB
Format : Hex


Thanks.

Luis Gomez B.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod