Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
Mark_O:
--- Quote from: Ivan7enych on March 07, 2014, 09:05:43 am ---UI of triggering is strange, for example I want to see RS232 data as ASCI chars, I see interesting place to me, and want to trigger on specific letter 'D' for example. For that purpose I need to find somewhere ASCI codes table and find the number of that letter. |O
--- End quote ---
Yes, that's definitely a PITA.
--- Quote ---Just because triggering UI works with numbers only, no letters, no HEX. :-//
I've found picture with another example, I2C decoding shows hex values, triggering works with dec values only.
--- End quote ---
Thanks for the screenshot on that. At first I was confused, but then I realized that while Rigol provides several different output formats, only one input format is available (decimal numerics). Thanks!
rowifi:
My DS2202A has locked up again..
This time I was messing with the measurement buttons and I believe it was the 'STATS' button that I pressed. The scope then goes unresponsive.
Basically I had ALL those yellow measurement readings on the screen and I was looking for a button to kill them. I could turn them all off , but haven't yet seen how to change them individually.
Whatever - the scope should not lock up, and worst - a power cycle does not fix it...
It sits there .. dead showing the Rigol logo. Scope is virtually new - unadulterated.
In all it seems a nice scope - but I'm going to get bored if I keep having to reflash the firmware every so often!
**UPDATE** Power cycle with 6th Grey button being repeated pressed has unlocked it... back in business.
bronson:
Twice?? That sounds like a broken scope. I'd file a support request.
rowifi:
Yes - done that, but since it happened both times since after I did a firmware upgrade, and only this timerecovered the scope using the '6th grey button' ( set defaults), I'm going to assume it was something to do with that ( for now)... ...
oh oh.... Just been trying it.. pressing the Statistic button has locked it up again.
Mode: Just channel 1 display ON. No Input signal. Display All ON. From a power up having only been messing with the measure functions.
I don't expect a power cycle to clear it alone....
Nope, just 3 beeps and then stuck.
Booting while pressing grey button no 6 fixes it.
I can't seem to replicate it... but so far each lockup has been related to the Display All , All Measure and Statistic buttons.
Edit:
Now I can repeat it ..
Power up:
Press 6th left hand grey button once ( to activate menu ) press again to select 'width'.
Press 7th left hand grey button to activate 'duty'
Press Measure
Check vertical channel 1 operates by adjusting knob
Press 'Statistic'
Check vertical channel 1 now doesn't operate. Scope is locked up and needs a reset to default to operate again.
hibone:
I've bought the Rigol 2072A-S. I was looking for the original firmware but the one in the first page is not available anymore.
Is it possible to update the page with a new link?
Thanks you...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version