| Products > Test Equipment |
| REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol |
| << < (464/566) > >> |
| Hydrawerk:
OK, I should have read the manual... |
| tigerwillow1:
My Wave Intensity always goes to 50% no matter what I attempt to set it to. Is this the same issue as in the previous few posts? Brightness adjusts the grid intensity and works ok. |
| JDubU:
--- Quote from: tigerwillow1 on April 03, 2014, 09:21:33 pm ---My Wave Intensity always goes to 50% no matter what I attempt to set it to. Is this the same issue as in the previous few posts? Brightness adjusts the grid intensity and works ok. --- End quote --- Pushing down on the intensity adjustment knob sets the intensity to 50% (it's a shortcut). Don't push it down after adjusting the intensity. Just stop turning the knob and the intensity will lock to your setting after a second or so. |
| tigerwillow1:
--- Quote from: JDubU on April 04, 2014, 12:14:01 am --- Pushing down on the intensity adjustment knob sets the intensity to 50% (it's a shortcut). Don't push it down after adjusting the intensity. Just stop turning the knob and the intensity will lock to your setting after a second or so. --- End quote --- OK, I didn't know that. I did read the "waveform intensity" part of the book. So now, the intensity setting stays where I set it, but it doesn't change the brightness of the waveform. Am I interpreting what the "waveform" is? I think it's the yellow and blue channel 1/channel 2 traces. I upgraded to 00.02.01.00.03 this morning. I "think" the intensity used to work ok, but my memory is not to be trusted, either. |
| JDubU:
--- Quote from: tigerwillow1 on April 04, 2014, 01:31:40 am --- --- Quote from: JDubU on April 04, 2014, 12:14:01 am --- Pushing down on the intensity adjustment knob sets the intensity to 50% (it's a shortcut). Don't push it down after adjusting the intensity. Just stop turning the knob and the intensity will lock to your setting after a second or so. --- End quote --- OK, I didn't know that. I did read the "waveform intensity" part of the book. So now, the intensity setting stays where I set it, but it doesn't change the brightness of the waveform. Am I interpreting what the "waveform" is? I think it's the yellow and blue channel 1/channel 2 traces. I upgraded to 00.02.01.00.03 this morning. I "think" the intensity used to work ok, but my memory is not to be trusted, either. --- End quote --- Yes, the waveform intensity control is the brightness of the traces. The range of brightness is not very dramatic. Try looking at the rise/fall transitions of the calibration waveform as you adjust the intensity. You should see the brightness change in them . |
| Navigation |
| Message Index |
| Next page |
| Previous page |