Products > Test Equipment

REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol

<< < (464/566) > >>

Hydrawerk:
OK, I should have read the manual...

tigerwillow1:
My Wave Intensity always goes to 50% no matter what I attempt to set it to.  Is this the same issue as in the previous few posts?  Brightness adjusts the grid intensity and works ok.

JDubU:

--- Quote from: tigerwillow1 on April 03, 2014, 09:21:33 pm ---My Wave Intensity always goes to 50% no matter what I attempt to set it to.  Is this the same issue as in the previous few posts?  Brightness adjusts the grid intensity and works ok.

--- End quote ---

Pushing down on the intensity adjustment knob sets the intensity to 50% (it's a shortcut).
Don't push it down after adjusting the intensity.  Just stop turning the knob and the intensity will lock to your setting after a second or so.

tigerwillow1:

--- Quote from: JDubU on April 04, 2014, 12:14:01 am ---
Pushing down on the intensity adjustment knob sets the intensity to 50% (it's a shortcut).
Don't push it down after adjusting the intensity.  Just stop turning the knob and the intensity will lock to your setting after a second or so.

--- End quote ---
OK, I didn't know that.  I did read the "waveform intensity" part of the book.  So now, the intensity setting stays where I set it, but it doesn't change the brightness of the waveform.  Am I interpreting what the "waveform" is?  I think it's the yellow and blue channel 1/channel 2 traces.  I upgraded to 00.02.01.00.03 this morning.  I "think" the intensity used to work ok, but my memory is not to be trusted, either.

JDubU:

--- Quote from: tigerwillow1 on April 04, 2014, 01:31:40 am ---
--- Quote from: JDubU on April 04, 2014, 12:14:01 am ---
Pushing down on the intensity adjustment knob sets the intensity to 50% (it's a shortcut).
Don't push it down after adjusting the intensity.  Just stop turning the knob and the intensity will lock to your setting after a second or so.

--- End quote ---
OK, I didn't know that.  I did read the "waveform intensity" part of the book.  So now, the intensity setting stays where I set it, but it doesn't change the brightness of the waveform.  Am I interpreting what the "waveform" is?  I think it's the yellow and blue channel 1/channel 2 traces.  I upgraded to 00.02.01.00.03 this morning.  I "think" the intensity used to work ok, but my memory is not to be trusted, either.

--- End quote ---

Yes, the waveform intensity control is the brightness of the traces.
The range of brightness is not very dramatic.  Try looking at the rise/fall transitions of the calibration waveform as you adjust the intensity.  You should see the brightness change in them
.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod