| Products > Test Equipment |
| REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol |
| << < (487/566) > >> |
| Orange:
--- Quote from: hans on May 08, 2014, 02:22:38 pm ---Has anyone had any problems with a Rigol DS1074Z(-S) scope not booting up from time to time? I believe I am running the SP5 firmware (which it came with, not sure if there is a new version 3.0 out yet) , and from time to time the scope just sits there and doesn't boot up. No lights from the front panel light up, and the screen just says Rigol. If I repower the scope it works fine. It has happened with both installed and uninstalled options key (still on trial period for a few hours). --- End quote --- This does not sound right. I got a new DS1104Z this week, and it boots every time correctly. It is running firmware 02.03.SP5, and was set-up with all options, except the 500uV. Pretty nice scope in addition to a DS2000. |
| Carrington:
Very good news, Sigrok now supports the RIGOL DS2000, and runs on windows! http://sigrok.org/wiki/Rigol_DS2000_series http://sigrok.org/wiki/Downloads |
| miguelvp:
--- Quote from: Carrington on May 08, 2014, 06:34:51 pm ---Very good news, Sigrok now supports the RIGOL DS2000, and runs on windows! http://sigrok.org/wiki/Rigol_DS2000_series http://sigrok.org/wiki/Downloads --- End quote --- Thanks, didn't even know this existed and it does support my DMM as well, good because the software that came with it is not that great. |
| Teneyes:
--- Quote from: Carrington on May 08, 2014, 06:34:51 pm ---Very good news, Sigrok now supports the RIGOL DS2000, and runs on windows! --- End quote --- Is CAN decoding after the data is transfered to the PC?? |
| Carrington:
--- Quote from: miguelvp on May 08, 2014, 07:32:39 pm ---Thanks, didn't even know this existed and it does support my DMM as well, good because the software that came with it is not that great. --- End quote --- You're welcome. I have been following the sigrok project for some time ago, however, the previous versions were not as easy to install on Windows. And yes, it supports a wide range of hardware: http://sigrok.org/wiki/Supported_hardware |
| Navigation |
| Message Index |
| Next page |
| Previous page |