Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
<< < (498/566) > >>
Teneyes:
@Nikwing

You may wish to try Roll mode at slow scan rate (10s/div)
then stop the scanning
and change Time Base faster to see more detail (100ms/div),
and scan though the stop display data for more detail
See : pics
Teneyes:
@Nikwing
You may wish to try triggering on each Pulse and recording the frames
Here is an Animating '.Gif' of 60 pulses at 120BPM
The playback is at 5 frames per sec so that is =  2.5 times the actual pulses rate
Teneyes:
@Nikwing
At this setting you can record 8128 Pulses
NikWing:
wow Teneyes :)

well, at first I try to measure just 5 mV to see if the gain stages work (using a 1:1 probe)
the curve is so "fat" that it's hard to see it move when I apply 5 mV to the circuit
I'm not yet to the point where I see a nicely looking heart beat like you show in your examples :o

I tried both, "default" and "last" in the settings, it happened with both (more than 1 try for both settings)
I'll give it another try :)
marmad:

--- Quote from: NikWing on June 21, 2014, 03:13:20 pm ---I tried both, "default" and "last" in the settings, it happened with both (more than 1 try for both settings)
I'll give it another try :)

--- End quote ---

Are you using FW v.3? If so, the new firmware has the new option 'Open' in the 'Power On' settings - although I have no idea exactly what it means. But you might try upgrading anyway, and see if it solves your problem.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod