Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
f1rmb:
Hi,
--- Quote from: Purevector on June 24, 2014, 04:37:37 pm ---
--- Quote from: Teneyes on June 24, 2014, 03:28:43 pm ---I went back to FW 00.01.00.05 and main power connect still starts my DS2072
I use SCPI command to get to LAST
--- End quote ---
That setting controls the setup information at startup; that's not what I'm talking about. In 3.01 there is a new setting called PowerStatus (you can see if if you scroll to the next page) The options are Open or Default. According the newest DS2000 manual on the Rigol website, Open mode powers up the scope when you plug it in, and Default just "energizes" the unit and you have to press the power button to power on the scope. I am stuck in Open mode after testing that setting and cannot get back to Default. I can change the setting and it appears to save the value, but the scope still powers up by itself.
We just had a power failure last night and the scope was on this morning because of this. I'll have to keep it unplugged to prevent it running if power is lost :(
--- End quote ---
Have you tried to reset stored settings (you know, left function keys column, F6 button while powering up).
Cheers.
EV:
--- Quote from: Purevector on June 24, 2014, 04:37:37 pm ---
That setting controls the setup information at startup; that's not what I'm talking about. In 3.01 there is a new setting called PowerStatus (you can see if if you scroll to the next page) The options are Open or Default. According the newest DS2000 manual on the Rigol website, Open mode powers up the scope when you plug it in, and Default just "energizes" the unit and you have to press the power button to power on the scope. I am stuck in Open mode after testing that setting and cannot get back to Default. I can change the setting and it appears to save the value, but the scope still powers up by itself.
We just had a power failure last night and the scope was on this morning because of this. I'll have to keep it unplugged to prevent it running if power is lost :(
--- End quote ---
Have you set also Utility-System-Power On-Last? Then the last settings should remain in use when you power on your scope.
Purevector:
--- Quote from: f1rmb on June 24, 2014, 05:13:42 pm ---
Have you tried to reset stored settings (you know, left function keys column, F6 button while powering up).
Cheers.
--- End quote ---
Yep, I tried to reset using F6. That was actually my first attempt at a fix. I also tried to load the default values through the menu.
Also, Power On "last" and "Default" works as it's supposed to, but neither solves the automatic boot-up issue.
Are there any others who are having this same problem?
f1rmb:
--- Quote from: Purevector on June 24, 2014, 05:35:33 pm ---
--- Quote from: f1rmb on June 24, 2014, 05:13:42 pm ---
Have you tried to reset stored settings (you know, left function keys column, F6 button while powering up).
Cheers.
--- End quote ---
Yep, I tried to reset using F6. That was actually my first attempt at a fix. I also tried to load the default values through the menu.
Also, Power On "last" and "Default" works as it's supposed to, but neither solves the automatic boot-up issue.
Are there any others who are having this same problem?
--- End quote ---
Well, and what about reflashing the firmware ?
Cheers.
Purevector:
Reflashed a bunch of times to almost all of the available versions. No change.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version