Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
<< < (512/566) > >>
Teneyes:
There also looks like an Error on the other end of the Persistence settings, It looks like there are different processing for these two settings
Below I show settings of 20 seconds and Infinite Persistence
marmad:

--- Quote from: Teneyes on August 25, 2014, 07:54:27 am ---Could this be SinX/X extrapolation??
It would nice to be able to turn off SinX/X .
--- End quote ---

I can't replicate this particular error on my Rigol, so I'm not sure what is causing it.


--- Quote ---Fuzzy Traces
--- End quote ---

The Siglent changes the grading a bit when when turning on more channels, but not nearly as much as the Rigol. In fact, the intensity grading on the Siglent is really quite beautiful - much better, in general, than the Rigol. I'm going to make an extra short video just about the intensity grading and post it in the next couple of days.


--- Quote ---It looks like Min. Presistence is set to an incorrect value!!!
and is about 200ms
--- End quote ---

Min. persistence is zero persistence - just intensity grading. And even though both intensity grading and persistence produce the same visual effect of shades of color, they are calculated and graded differently (although I don't know exactly how Rigol is doing it).
Teneyes:

--- Quote from: marmad on August 25, 2014, 07:19:32 pm ---
--- Quote from: Teneyes on August 25, 2014, 07:54:27 am ---Could this be SinX/X extrapolation??
It would nice to be able to turn off SinX/X .
--- End quote ---
I can't replicate this particular error on my Rigol, so I'm not sure what is causing it.

--- End quote ---
to Clarify , the setup is :
    FW 00.03.00.01.03
    300MHz options, all Options installed??
    mostly observed on 5nsec/div
    70 MHz input
    2 channels On
    Memory Depth = 28MPts, , AUto sets to 700 Pts and Blurs  traces
    Single scan to show ripple  (less ripples with only 1 chan on)

DIsplays with DOts and Vectors at Infinite Persiostence
marmad:

--- Quote from: Teneyes on August 25, 2014, 08:16:14 pm ---    70 MHz input

--- End quote ---

It has to be a 70MHz input @5ns/div? That seems like a pretty specific bug  ;D
Teneyes:

--- Quote from: marmad on August 25, 2014, 09:16:15 pm ---It has to be a 70MHz input @5ns/div? That seems like a pretty specific bug  ;D

--- End quote ---
Well   ;D, It shows on the peaks of 30-120 Mhz, and more at 5ns/div.
I say it is a quirk of the SinX/X implementation

I un-installed all Options an only added 56MPts back

Here are Gifs. , of Vectors and Dots Recording  with 50MHz input ON FW00.03
Note how the dots are follow on the sin curve but in VECTORS there is a rolling ripple of 1 GHz !!   :-//

The next Post will be on FW 00.01
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod