Products > Test Equipment

REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol

<< < (516/566) > >>

Galaxyrise:

--- Quote from: marmad on September 21, 2014, 11:08:56 am ---As already mentioned, High Res is, at best, marginally useful at those time bases, causing the BW of the DSO to be reduced to below 250 Hertz.

--- End quote ---
I have used high res and slow time bases to watch thermistors and the like, but I'm usually doing that stuff in roll mode.  I don't suppose Roll mode would work for you, Circlotron?  If not, remember you can turn on high res after the capture is complete when in Y-T mode.

Circlotron:

--- Quote from: Galaxyrise on September 22, 2014, 06:53:01 pm --- remember you can turn on high res after the capture is complete when in Y-T mode.

--- End quote ---
I only just the other day discovered that. Game changer.  ^-^

alank2:

--- Quote from: alank2 on September 21, 2014, 10:54:23 pm ---Is the FW#00.03.00.01.03 stable and solid?  Better than the 00.02.01.00.03?  Any tricks to upgrading?  I've got two non-A DS2072's.

--- End quote ---

Anyone?  I know you guys are on top of this!

marmad:

--- Quote from: alank2 on September 23, 2014, 11:33:03 pm ---
--- Quote from: alank2 on September 21, 2014, 10:54:23 pm ---Is the FW#00.03.00.01.03 stable and solid?  Better than the 00.02.01.00.03?  Any tricks to upgrading?  I've got two non-A DS2072's.

--- End quote ---

Anyone?  I know you guys are on top of this!

--- End quote ---

FW v.3 is fine - and, as reported earlier in this thread, has added features. I've been using it for months without any noticeable problems. Upgrading is the same as always.

alank2:
Thanks Marmad, I appreciate the information!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod