Products > Test Equipment

REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol

<< < (531/566) > >>

korlatos:
Hello,

Has anybody successfully installed and used the CAN decoder option on DS2072 (non-A) with 2.0 HW?

korlatos:
Thank you for the link, but that is a DS2072A scope. I know that Rigol added CAN decoding and 50 ohm termination to the A model, but the question is whether CAN decoder can be enabled on non-A models with current firmware (03.03.01).

EV:

--- Quote from: korlatos on February 03, 2015, 10:00:56 pm ---Thank you for the link, but that is a DS2072A scope. I know that Rigol added CAN decoding and 50 ohm termination to the A model, but the question is whether CAN decoder can be enabled on non-A models with current firmware (03.03.01).

--- End quote ---

Yes it can!

korlatos:
Great - thank you!

Teneyes:
Here is My DS2072  test with FW 00.03.03.01.00,,
I did have problems with trigger setup at 1st but finally it worked ?????

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod