Products > Test Equipment
REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol
<< < (539/566) > >>
nbritton:
How many years of service do you figure you can get out of a 2000A? Am I right in assuming that the first thing to go on these is the capacitors in the power supply?
Teneyes:

--- Quote from: nbritton on September 16, 2015, 08:36:04 am --- Am I right in assuming that the first thing to go on these is the capacitors in the power supply?

--- End quote ---
No, the caps are Ok
See Dave's tear down , at 5 min.


There were some failure points, but  corrections have been made in the production.
Time will tell
EV:
Are there any FW updates after ver 00.03.03.02.06?

I have downgraded back to ver 00.03.03.01 as I told some posts ago.
JDubU:

--- Quote from: EV on September 16, 2015, 04:15:43 pm ---Are there any FW updates after ver 00.03.03.02.06?

I have downgraded back to ver 00.03.03.01 as I told some posts ago.

--- End quote ---

This page shows all of the current firmware versions:
http://beyondmeasure.rigoltech.com/acton/form/1579/0012:d-0001/1/index.htm
EV:

--- Quote from: JDubU on September 16, 2015, 04:20:20 pm ---This page shows all of the current firmware versions:
..

--- End quote ---
Thanks, so no new updates yet. The latest is that buggy one!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod