Products > Test Equipment

REVIEW - Rigol DS2072 - First Impressions of the DS2000 series from Rigol

<< < (539/566) > >>

nbritton:
How many years of service do you figure you can get out of a 2000A? Am I right in assuming that the first thing to go on these is the capacitors in the power supply?

Teneyes:

--- Quote from: nbritton on September 16, 2015, 08:36:04 am --- Am I right in assuming that the first thing to go on these is the capacitors in the power supply?

--- End quote ---
No, the caps are Ok
See Dave's tear down , at 5 min.


There were some failure points, but  corrections have been made in the production.
Time will tell

EV:
Are there any FW updates after ver 00.03.03.02.06?

I have downgraded back to ver 00.03.03.01 as I told some posts ago.

JDubU:

--- Quote from: EV on September 16, 2015, 04:15:43 pm ---Are there any FW updates after ver 00.03.03.02.06?

I have downgraded back to ver 00.03.03.01 as I told some posts ago.

--- End quote ---

This page shows all of the current firmware versions:
http://beyondmeasure.rigoltech.com/acton/form/1579/0012:d-0001/1/index.htm

EV:

--- Quote from: JDubU on September 16, 2015, 04:20:20 pm ---This page shows all of the current firmware versions:
..

--- End quote ---
Thanks, so no new updates yet. The latest is that buggy one!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod