Products > Test Equipment
First picture on EEVblog of the new R&S MXO4 series oscilloscope :)
goaty:
Settings are the same or comparable ? Like trigger level ?
Update rate on the RTB2k also varies a lot and does rarely reach 50k/s.
2N3055:
--- Quote from: EEVblog on February 07, 2023, 06:15:13 am ---
--- Quote from: EEVblog on February 07, 2023, 02:49:24 am ---Finishing shooting the MXO4 unboxing video and tried to test the 4.5Mwfms/sec update, and, well, I don't see it :-//
--- End quote ---
I had the measurements turned on. They said they are going to improve this in future firmware. So much for the ASIC.
--- End quote ---
That is analytic scope. It is not used that way...
And 4.5 Mtriggers in segmented mode is very good and very useful.
Set scope to long capture and set search for pulse width less than normal clock width. You will have 100% POI.
Or use pulse width trigger, with segmented mode, and assemble statistics of how glitch happens... Also 100% POI..
goaty:
I wonder why there is this huge "blind time" of more then a millisecond.
That must be some parameters.
Of course one can use fast segmentation mode, but why it needs so much time between triggers ?
armandine2:
analytic scope versus a display scope?
bozidarms:
--- Quote ---That is analytic scope.
--- End quote ---
"Analytic scope" without at least Trends, Tracks and Histograms???
I don't really believe that...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version