Products > Test Equipment
First picture on EEVblog of the new R&S MXO4 series oscilloscope :)
EEVblog:
--- Quote from: nctnico on February 08, 2023, 10:17:05 pm ---Seems reasonable to me as the data needs to be processed for the measurement. Ofcourse there is a choice between using only the Nth acquisition to base calculations on OR doing calculations on all acquisitions. In the first option there is a disconnect between what is shown on screen and what is being calculated.
--- End quote ---
Not when you realise that the veritcal measurements and cursors have absolutely no impact at all on the waveform speed. It's only very specific horizontal measurements like Frequency which drops the update rate three orders of magnitude.
nctnico:
--- Quote from: EEVblog on February 08, 2023, 10:19:07 pm ---
--- End quote ---
If you use an R&S scope for a while, you'll see that using the 'Nsingle' setting for doing a segmented recording is a very efficient way to setup a segmented recording sequence. But I agree it isn't very standard and takes some getting used to. I just used it myself a couple of days ago (on the RTM3004).
Fungus:
If only there were things called manuals where you could go and type the word "single" and have the answer in a few seconds:
https://scdn.rohde-schwarz.com/ur/pws/dl_downloads/pdm/cl_manuals/user_manual/1335_5337_01/MXO4_UserManual_en_03.pdf
( :box: )
BU508A:
Marco Reps is measuring the noise of some ADR1000 with a MXO4:
https://youtu.be/mmsBT3Fuggk?t=3030
He uploaded the video two days ago.
EEVblog:
--- Quote from: Fungus on February 09, 2023, 04:24:33 am ---If only there were things called manuals where you could go and type the word "single" and have the answer in a few seconds:
--- End quote ---
Except when the manual is wrong. You have to go into the Segmented menu to find the option to change it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version