| Products > Test Equipment |
| Kunkin KP184 electronic load : "fixing" an manufacturer issue |
| << < (3/7) > >> |
| interflexo:
--- Quote from: interflexo on April 25, 2020, 10:21:15 am ---My tested unit has warranty seal dated 16 Nov 2019, PCB VER.03, MOSFETs IRFP250M (P820J) dated from 2008 and no C58 capacitor soldered. --- End quote --- I tested a unit bought in 2020 that came without the capacitor installed from factory. |
| voltlog:
Please note that date of purchase is not all that relevant as most sellers on ebay and aliexpress are probably selling older stock. A good indicator is the revision of the mainboard and/or the warranty sticker, in my case it is REV.04 with warranty sticker of FEB 2020, as far as I can tell this might be the newest revision Kunkin makes. |
| Falkra:
Thank you. :) |
| TSCOLAN:
Hi, In case somebody have the Kunkin KP182, the board is the same, and the fix woks also. Thomas |
| ScoobieSnax:
Hi, my kp184 is a VER.01 bought on Ebay in July 19. I had the same ripple current and i applied the cap removing saw in the cyrob (aka PhilDem) video, ripple current is almost gone. Maybe i'll resolder a 10nF later. But the most annoying with my model is the voltage measurement who stops without reasons (as described in the calibration procedure pdf - page 4). I have the same problem as Voltlog with the kunkin mailbox (Connection timed out), so i can't describe the problem to Kunkin |O. I don't even know if there is a solution to solve this problem. Does anyone have the same bug ? Thony |
| Navigation |
| Message Index |
| Next page |
| Previous page |