EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: eb4eqa on September 21, 2014, 06:08:55 pm
-
Hi,
I've been using this adapter I made for some time and it was about time to share it with you guys.
I stole the idea from one of Mike's videos where he suggested PCB could be used but I never actually saw one like this. It is made from 1.6mm PCB stock and the 20mm ZnSE lens is simply press-fitted. To place the adapter in the camera you simply insert one side against the wall, compress the other side with a nail or a tool and release it after the PCB is laying flat on the bottom of the camera. It does not scratch the camera and it won't fall easily at all. You need to put the camera quite close to the subject to get it in focus, just fine.
I'm attaching the .DXF file so you can generate the G-Code of your choice.
Best regards,
Roberto EB4EQA