Products > Test Equipment

Fluke 117 'F11- Err' is it possible to repair?

(1/1)

chebo:
My Fluke 117 started showing an 'F11- Err' error when turned on. I think his firmware crashed.
It broke after I tried to measure the voltage of its own battery with it. When you touch the minus of the battery with the "-" probe, the display goes out. After several touches, the device began to show this error. (Does anyone want to repeat it? ;))
Is it possible to repair? Maybe replace the controller? They are available on Aliexpress. But it should probably already be programmed for this model?

Fungus:
Yeah, don't do that...

https://www.eevblog.com/forum/testgear/fluke-87v-_bricked_-when-probing-own-battery/

BeBuLamar:
And also Fluke doesn't repair the 11x series meters. If under warranty they would simply replace it but they said they don't repair them.

chebo:
Ok, i got it, thanks! )))

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod