Products > Test Equipment
Fluke 123 Scopemeter and battery replacement
<< < (7/18) > >>
mojoe:
I took my dead battery pack to a Batteries Plus store to have it rebuilt. It only costs me $12. If you have something similar in your country, I would take it there.
EIKA:

--- Quote from: mojoe on April 02, 2016, 04:56:10 am ---I took my dead battery pack to a Batteries Plus store to have it rebuilt. It only costs me $12. If you have something similar in your country, I would take it there.

--- End quote ---

I can do it by myself. Why not?
wptski:
They are SUB C cells.
EIKA:
Yes. Just measured them. 22.4 mm diameter and 42.5 mm height w/o + tip. With tip it might be ~43 mm. So, it's usual SUB C  :-/O
EIKA:
Hi all!

I've bought the BP130 battery off eBay http://www.ebay.com/itm/161759037081, from cellephone-express seller based in Germany.

It's aftermarket one, I know. And after I got it I immediately found out that It’s 4 wires only, but not 5 as OEM one.

And all looks like it can't be charged when installed into Fluke 124. Nothing changes after 20 hours plugged to PSU. No charging process, no battery warming, etc. it was flat and it's now flat. Battery refresh can't be run - device switches off immediately. Looks like it's cheap Chinese junk / rip-off.

PSU is OEM, device is brand new. Wall socket is 100% working and switched on all the time.

Picture of this battery attached below.

DON'T BUY THIS JUNK!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod