| Products > Test Equipment |
| Fluke 123 Scopemeter and battery replacement |
| << < (8/18) > >> |
| EIKA:
After some time of reviewing both batteries I decided to swap wire harnesses with all components (excluding the thermistor). Installed old harness on fresh cells battery and left the rest stuff on the shelf. As result I got 5th line (additional positive), proper connector with locking tab, and proper ID resistor as well. BTW, old resistor was 3,9 MOhm instead of OEM's 821 Ohm. Now it takes charge well. Damned Chinese guys, what the hell they doing? Reported to seller, but I am not sure that it will follow me. |
| BFX:
Yes I bought also this battery but I found soon that there is chinese bug as usually :) For me is only surprise that this product sell german company. I warned them about it about half a year ago. |
| EIKA:
I think that they will ignore and it's a reason why I already left negative for them. |
| teksturi:
I also buy that same battery pack. Put new resistor and change positive connector to other hole in the connector. When I go to battery refresh page my unit say that battery refreshing take only 12 hours. My unit software version is 01.02. Edit: I found a answer from fluke web page http://www.fluke.com/fluke/tten/support/software/ScopeMeter_Firmware_Upgrades.htm Version 2.02 update notes says: "Battery refresh time changed from 12 to 19 hours to reflect the real situation (V2.02)" |
| EIKA:
Thanks! Good to know. |
| Navigation |
| Message Index |
| Next page |
| Previous page |