Products > Test Equipment
Fluke 123 Scopemeter and battery replacement
<< < (18/18)
Uzunov:
Hello everyone! I recently got a fluke 123 and its battery is naturally dead. I'm thinking of replacing it with two lithium batteries as described in the topic, but I couldn't figure something out. When doing this conversion what resistor should be put to the battery sense pin!? Should it be 825 ohms or 0 or does that no longer matter. The device is one of the oldest and may not recognize a nimh battery.

The translation from Bulgarian was made with Google Translate and there may be inaccuracies.

Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod