Fluke 175 capacitance autohold

[hhhh]

175 is my first fluke, so bare with me.

I measured some caps just to test it out, and I noticed that the autohold does not work when measuring capacitance. It does work with voltage.

Autohold activates just fine, but that's it. No measurements with autohold. The normal mode works fine.

Can Anyone check if this is by design? I used a 2200uf electrolytic out of circuit.

EDIT:
I works, it just takes about 10 seconds to display the value. Using the regular mode the value is instant and stable, but I guess it's not somehow stable enough for the autohold.