Products > Test Equipment
Fluke 189 with leaking surface mount supercap (also Fluke 287, Fluke 289)
dr.diesel:
--- Quote from: BravoV on November 07, 2013, 02:28:32 am ---
Same capacitance as original cap at 0.2F 3.6V, and cost $2.79 a pop at Digikey -> EDLRD224H3R6C, has two terminals styles like above pics, just abit bigger than original cap and not much, and I think its still manageable like by bending it's legs to fit in the solder pads.
--- End quote ---
Yup, this one should fit no problem, and probably last longer like you said. :-+
dr.diesel:
For anyone wondering, Digikey part#P11068CT-ND is a perfect fit for the original on the 289.
BravoV:
--- Quote from: dr.diesel on November 08, 2013, 04:50:57 pm ---For anyone wondering, Digikey part#P11068CT-ND is a perfect fit for the original on the 289.
--- End quote ---
Did you purchase that ? Digikey currently don't carry it anymore for cut tape, and also I can't find the datasheet at Panasonic for this product type, another discontinued series ? :-//
dr.diesel:
--- Quote from: BravoV on November 09, 2013, 01:43:31 pm ---
--- Quote from: dr.diesel on November 08, 2013, 04:50:57 pm ---For anyone wondering, Digikey part#P11068CT-ND is a perfect fit for the original on the 289.
--- End quote ---
Did you purchase that ? Digikey currently don't carry it anymore for cut tape, and also I can't find the datasheet at Panasonic for this product type, another discontinued series ? :-//
--- End quote ---
Sure did:
BravoV:
Damn, I guess I was blind when I browse the Digikey. :palm:
Btw, that Panasonic cap doesn't have any datasheet, and at the DK page its rated with lifetime @ Temp. 500 Hrs @ 60°C.
Just fyi, at the CDE type ELDR ultracap I pointed previously, after the exposure of 2000 h at +85 ºC ,still capable of maintaining ±30% of the initial measured value.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version