Products > Test Equipment
FLUKE 192/ 196 / 199 FW Upgrade
asis:
Hi,
I do not yet have a dump on devices of older versions of Fluke 192,196,199 (without the letter B, C).
There the MS TE28F160B3xxxxx 16MB Flash or M5M29FB160AVP-80 is installed and, probably, dump substitution is hardly possible.
There OTP ROM D-ASIC checks the serial number of your device, which is located on the back of your device.
Look at the algorithm and try to use the rollback procedure.
Not the fact that the devices purchased at the auction are not rearranged from one case to another.
Keep that in mind.
Vladimir.
mojoe:
My understanding is that the early Scopemeters with 1.xx firmware won't take the later firmware. It would be nice if you prove this incorrect.
lostking2008:
Hi There, I need a memory module for Fluke 199C, but it has been discontinued by Fluke back in 2017. Unfortunately, the service manual doesn't come with the circuit drawing of the Flash/SRAM module (80 contacts in two rows, 0.8mm pitch) itself. Does anyone happen to have a schematic drawing of the memory module?
Thanks,
Ken
vishaldotgupta:
hi
can anyone share flash file bin / hex file for Fluke 199c
asis:
https://www.eevblog.com/forum/repair/fluke-199c-scopemeter-repair/25/ 8)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version