| Products > Test Equipment |
| FLUKE 192/ 196 / 199 FW Upgrade |
| << < (5/5) |
| coromonadalix:
Must be them http://scopemeterrepair.com/ |
| Victor jose teixeira:
Good afternoon, I have several FLUKE devices, multimeters and oscilloscopes. I recently bought a FLUKE 199 on Ebay in excellent condition and with calibrations, it already had firmware version V04.08 (last), the multimeter measurement works. But the functions OSCILLOSCOPE channel A and B do not measure, the lines of channels A and B do not appear. I've tried several configurations and nothing, the tips are fine, the problem is really in the oscilloscope. Someone can help me? Any idea what the problem is? |
| Victor jose teixeira:
--- Quote from: Victor jose teixeira on April 29, 2023, 06:49:06 pm ---Good afternoon, I have several FLUKE devices, multimeters and oscilloscopes. I recently bought a FLUKE 199 on Ebay in excellent condition and with calibrations, it already had firmware version V04.08 (last), the multimeter measurement works. But the functions OSCILLOSCOPE channel A and B do not measure, the lines of channels A and B do not appear. I've tried several configurations and nothing, the tips are fine, the problem is really in the oscilloscope. Someone can help me? Any idea what the problem is? --- End quote --- |
| eb4fbz:
--- Quote from: Maxis on November 06, 2019, 10:56:42 am ---More information: The built in CPU is indeed the bare bone 68000! No instruction set extensions common for 010-060 are identified. The flash ROM starts at the physical address 0x680000 >:D in the D-ASIC address space. The first 512K are empty (at least in rev 4.00 and 4.08). The actual code content starts at 0x700000 --- End quote --- Are you sure? Fluke Spider D-ASIC (HS353063) is supposed to use an ARM 720 core. |
| smaultre:
Looks like bad input asic (or problems with it powering) You can try the pre-calibration diagnostic procedure. |
| Navigation |
| Message Index |
| Previous page |