Products > Test Equipment
FLUKE 192/ 196 / 199 FW Upgrade
coromonadalix:
Must be them
http://scopemeterrepair.com/
Victor jose teixeira:
Good afternoon,
I have several FLUKE devices, multimeters and oscilloscopes.
I recently bought a FLUKE 199 on Ebay in excellent condition and with calibrations, it already had firmware version V04.08 (last), the multimeter measurement works. But the functions OSCILLOSCOPE channel A and B do not measure, the lines of channels A and B do not appear.
I've tried several configurations and nothing, the tips are fine, the problem is really in the oscilloscope. Someone can help me? Any idea what the problem is?
Victor jose teixeira:
--- Quote from: Victor jose teixeira on April 29, 2023, 06:49:06 pm ---Good afternoon,
I have several FLUKE devices, multimeters and oscilloscopes.
I recently bought a FLUKE 199 on Ebay in excellent condition and with calibrations, it already had firmware version V04.08 (last), the multimeter measurement works. But the functions OSCILLOSCOPE channel A and B do not measure, the lines of channels A and B do not appear.
I've tried several configurations and nothing, the tips are fine, the problem is really in the oscilloscope. Someone can help me? Any idea what the problem is?
--- End quote ---
eb4fbz:
--- Quote from: Maxis on November 06, 2019, 10:56:42 am ---More information:
The built in CPU is indeed the bare bone 68000! No instruction set extensions common for 010-060 are identified.
The flash ROM starts at the physical address 0x680000 >:D in the D-ASIC address space.
The first 512K are empty (at least in rev 4.00 and 4.08). The actual code content starts at 0x700000
--- End quote ---
Are you sure? Fluke Spider D-ASIC (HS353063) is supposed to use an ARM 720 core.
smaultre:
Looks like bad input asic (or problems with it powering) You can try the pre-calibration diagnostic procedure.
Navigation
[0] Message Index
[*] Previous page
Go to full version