Products > Test Equipment

Fluke 287 289 Firmware update version 1.16 now posted

<< < (6/7) > >>

elex_enthusiast:
does the new firmware update requires calibration? :-DMM

Uup:
I don't think calibration is required after an update, unless the firmware you are updating from would necessitate it (very early revision). I updated my 289 from 1.13 and didn't require a calibration.

ben_r_:
Yea shouldnt require an new calibration.

elex_enthusiast:
i just updated my 287 and had no problem so far after updating the firmware from 1.12 version...the accuracy remains the same..thanks to fluke..
if ever you found something bad with your meter after updating please tell us..

Chalky:

--- Quote from: Nermash on May 25, 2013, 06:31:23 pm ---Real (cheapass) engineers don't like paying 50€ or 70 $ for FTDI chip and 2 IR diodes  ;)

--- End quote ---
Hey Nermash (or anyone), do you reckon, in theory that a similar homemade cable based on Silicon Labs CP210x would work on my 287?  Not having any luck, firmware app won't connect, and can't see anything with serial comms software (e.g. Hyperlink).  Cable works 100% fine on my Scopemeter 196.

Cheers.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod