Products > Test Equipment
Fluke 287 289 Firmware update version 1.16 now posted
ron:
This was posted on Fluke site today. I just finished updating 2 289 meters without any trouble. Didn't even have to reset date/time.
http://www.fluke.com/fluke/usen/support/software/DMMUpgrade.htm
I did the upgrades just for the heck of it. I never experienced any problems with previous firmware. Really, how hard is it not to aim the IR port directly at the sun for more than 5 minutes?
ben_r_:
Cool. Updating now...
ben_r_:
Done! 1.14 to 1.16.
Now problems Ive never experienced are cured :)
ElektroQuark:
1.14?
The last downloadable version was 1.10.
1.16 now.
AndyC_772:
The last posted update might have been 1.10, but clearly some meters have interim versions installed that were never posted as updates. Mine's on 1.12, and it's staying there... no point in risking an update for such a trivial fix. If I need to data log for a long time in bright sunshine, I can put a bit of tape over the sensor.
Navigation
[0] Message Index
[#] Next page
Go to full version