EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: scopeman on March 24, 2021, 11:36:00 pm

Title: Fluke 37 Missing the bottom stand - Does anyone have one they would part with?
Post by: scopeman on March 24, 2021, 11:36:00 pm

Does anyone have the bench stand for the Fluke 37? I bought one that is missing that part.

Thanks,

Sam
W3OHM
Located in the USA

Title: Re: Fluke 37 Missing the bottom stand - Does anyone have one they would part with?
Post by: modz786 on March 26, 2021, 06:15:24 am

perhaps if you also ask that someone might 3D print a replacement for a few beers might work  :)

Title: Re: Fluke 37 Missing the bottom stand - Does anyone have one they would part with?
Post by: scopeman on March 26, 2021, 02:17:44 pm

Yes but I would need a dimensional drawing start with and I don't even have that.

Thanks,

Sam
W3OHM