Products > Test Equipment

Fluke 376FC or 378FC Alternatives

(1/2) > >>

bpan:
A while ago I was asking here about multimeters and what you all thought of Flir. Anyhow, I purchased a Flir, but don't love it so it is going back.

I really like the interface and ease of use on my Fluke 88V. The screen is well done, the button and function layouts are easy to operate and make sense.

Before I go buy a Fluke 376FC or potentially a 378FC do you guys have any other suggestions?

Ugur:
To answer that, we need to know what you really need. If you don't measure very high current, I can also recommend the Fluke 325.

BeBuLamar:
The 378FC is very expensive because it has non contact voltage measurement. I am not sure if this feature works well. The 325 which is less expensive than any of the 37x models does have higher resolution in current measurement.

multiJ:
Fluke 319 can be an option if you can find them in your place of the world
https://www.fluke.com/en-in/product/electrical-testing/clamp-meters/fluke-317-319

bpan:
Thank you all for the suggestions, I think this has helped narrow it down for me completely! I am going to go with either the 376FC or the 378FC. (most likely the 376FC) I get into everything from low current 12v, occasinally up to 347V 3 phase and everything inbetween. My max amperage I have needed until this point is 400A, so a 600A rating is fine, but I would be ok with more.

One thing that bugs me about the 325 and the 319 suggested are that there is 1 selection for VAC and VDC. I like to have those on a separate dial selection.

Thanks again guys, you are all so fast to help out!

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod