Products > Test Equipment
Fluke 6060A/AN Uncal Error
davorin:
Yepp...crap Chinese probe cable (o; Not meant for 50Ohm....
Connected 2 * 100R in parallel directly to output and now it's correct with +/- 1.4V pkk
Technotronic:
I own one of these, very beat up condition and it didnt power up last week. Turns out it was a 10uF/35V cap inside the synth
chassis shorted. Installed in 1985, 38 yrs with 37v on it , its failed. I replaced with an electrolytic and now powers up but
theres no signal output and have the uncal error with status 004 which is "amplitude unleveled" ?
Is there suppose to be a battery in these to keep memory?
Navigation
[0] Message Index
[*] Previous page
Go to full version