Products > Test Equipment
Fluke 732B DC Standard Teardown
branadic:
--- Quote --- I made a LM399 standarsd, still planning to ovenise the whole thing and buils it in the 731A housing.
--- End quote ---
Do you want to share your schematics? What does it look like?
I've build the "10V Buffered Reference" from LinearTechnology datasheet with LT1001 in ceramic package with 5ppm/K 0805 chip resistors for gain setting and a crystal heater on top (40.8±1.5°C but <0.1K regulation accuracy). The reference is now running several weeks on a 34401A under lab conditions (~22.4±0.5°C) and I can observe a drift by ±10µV correlating with humidity in the lab (corner value 1 RH<40%, corner value 2 RH>45%).
Can't say if this is a sensitivity of my reference or the 34401A.
I'm still searching for the ultimate circuit. One idea could be a LM334 current source in hermetical package feeding the LM399 combined with a chopper amp at the output.
So I'm interested in your solution.
SimonSatCom:
Very nice teardown. At the moment I'm trying to build my own precision reference using the LTZ1000A.
http://www.simonthenerd.com/LTZ1000A.htm
I have used the Fluke 732B as kind of my reference so it is nice to see some real pictures from inside the beast. :)
VR2XGI:
any Fluke 732A teardown?? :-+
VR2XGI:
--- Quote from: amyk on April 08, 2013, 11:23:19 am ---Here you can see the resistors in the oven taken out(!):
http://bbs.38hot.net/thread-177-1-1.html
Interesting shape to them...
--- End quote ---
38hot is a very good forum , I have been there many year :-+ :-+ :-+
Smokey:
Link with the pictures from OP: https://xdevs.com/doc/Fluke/732B/Fluke%20732B%20DC%20Standard%20Teardown%20-%20Page%201.pdf
Navigation
[0] Message Index
[*] Previous page
Go to full version