Products > Test Equipment
Fluke 8050A calibration
<< < (6/7) > >>
CDaniel:
Half range should be fine , and if for some reason it's not perfectly linear here is a good point for compromise
maginnovision:
If it weren't for COVID I'd offer to let you use my calibrator... Perhaps later. Assuming 91343 is your zip we're practically neighbors.
bob91343:
Yes that is my zip.  Where are you?
maginnovision:
Near the mission police station.
JimS:
I was working on a 8050 about 2 weeks ago.
It had been on a shelf unused for around the last 3 years if not more.
The ohm's with a shorting bar was off on every other ohms range.
A good spray cleaning of the switches and it was ok after that.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod