Products > Test Equipment

Fluke 87V switch's white mark

<< < (3/5) > >>

Martin72:
Me, I would contact Fluke for this when it´s so important, telling them the concerns of having a fake product and wait for their answer.
Everything else are speculations.

Fungus:

--- Quote from: Martin72 on December 03, 2022, 12:05:43 pm ---Me, I would contact Fluke for this when it´s so important, telling them the concerns of having a fake product and wait for their answer.
Everything else are speculations.

--- End quote ---

It's not going to be "fake", but it might be a grey import.

OTOH they might have run out of white paint that day and the boss said "make them anyway!".

Mechatrommer:

--- Quote from: Fungus on December 03, 2022, 12:53:12 pm ---It's not going to be "fake", but it might be a grey import.

--- End quote ---
what does it mean grey market? legit instruments from legit factory, is just through unauthorized channels? or less than par certification/calibration/reject result sold in unauthorized channels? or else? what? if i really care about white mark, i'll use pen correction liquid, 1 second fix.

Martin72:

--- Quote ---It's not going to be "fake"
--- End quote ---

Just to attract a bit more attention, given the amount of emails they might get every day. ;)

Arhigos:
Older 87v had white painting. New 87v doesn't have it anymore.

Also old 87v had a shaft from stainless steel inside knob. New 87v knob is fully made from plastic.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod