Products > Test Equipment
Fluke 8846A - anyone that got the updated firmware downloaded?
<< < (5/7) > >>
Miti:
Thanks Erik, my meter is 2.10.882.24 but looks like it is not the latest. Take a look.
dacman:
The (last) OutG firmware update that was available online (that I know of) was the one shown in the last picture.

The later SW may be due to the HW change, and therefore might not be compatible with earlier hardware.
ErikTheNorwegian:
Hi  alezarate

regarding problem conecting tru ethernet:

https://www.eevblog.com/forum/chat/unable-to-establish-connectivity-with-fluke-8846a-using-ethernet/msg146310/#msg146310


Erik
John_ITIC:
Hello- resurrecting this old thread since i didn't find any more relevant one.

I have a Fluke 8846A (serial # 9451014, OutG SW 1.0.xxx). I understand the newer 2.1 or 2.3 FW supports "Fluke 8842A Emulation Mode", which I need for some some pre-compiled software.

If anyone has it I would greatly appreciate if I could get my hands on it (link via PM, perhaps).

Thanks!
/John.
dan46n2:
Does anyone still have the updated firmware they could send me or post a link?  I just got a used 8845A and it has the old firmware on it.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod