Products > Test Equipment

Fluke 8846A - anyone that got the updated firmware downloaded?

<< < (5/7) > >>

Miti:
Thanks Erik, my meter is 2.10.882.24 but looks like it is not the latest. Take a look.

dacman:
The (last) OutG firmware update that was available online (that I know of) was the one shown in the last picture.

The later SW may be due to the HW change, and therefore might not be compatible with earlier hardware.

ErikTheNorwegian:
Hi  alezarate

regarding problem conecting tru ethernet:

https://www.eevblog.com/forum/chat/unable-to-establish-connectivity-with-fluke-8846a-using-ethernet/msg146310/#msg146310


Erik

John_ITIC:
Hello- resurrecting this old thread since i didn't find any more relevant one.

I have a Fluke 8846A (serial # 9451014, OutG SW 1.0.xxx). I understand the newer 2.1 or 2.3 FW supports "Fluke 8842A Emulation Mode", which I need for some some pre-compiled software.

If anyone has it I would greatly appreciate if I could get my hands on it (link via PM, perhaps).

Thanks!
/John.

dan46n2:
Does anyone still have the updated firmware they could send me or post a link?  I just got a used 8845A and it has the old firmware on it.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod