Products > Test Equipment
Fluke custom USB-IR cable
dgm_mixtoon:
hello, can you share the DIY?
the link is dead :/
walter.aranda:
Hello, I am developing a small Python program that allows logging data from the multimeter 189 to a PC. I have successfully transferred data and saved it on the PC. Now, I would like to make some improvements, but I can't find the information I need. If anyone knows anything, it would help me a lot:
1. Is it possible to transfer the logging memory data from the multimeter to the PC? What serial command is used?
2. Is there any command to sample data from the second display and transfer it to the PC log?
stj:
did you look at sigrok?
walter.aranda:
--- Quote from: stj on July 10, 2024, 01:11:23 pm ---did you look at sigrok?
--- End quote ---
That's right, I installed Sigrok some time ago, however, I haven't been able to connect since the program doesn't recognize the IR cable driver (original). I know the driver is correctly installed because I've tested it with a test program based on Python, and it works properly. I can even do logging and save it on the PC. It might be that the driver I'm installing is not suitable for the program. Could you send me the driver for this cable? I'll send you a PrtSC and the driver I'm using.
stj:
if your using serial convertors from prolific you must use an old driver.
the newest drivers wont work with some older chips
Navigation
[0] Message Index
[*] Previous page
Go to full version