Products > Test Equipment
Fluke/Tektronix Bushealth Code: 192C/196C/199C/215C/225C/190 (I & II) THS3000
<< < (7/8) > >>
squadchannel:
 :-+
FlexibleMammoth:

--- Quote from: patpat on October 19, 2024, 09:45:25 pm ---@FlexibleMammoth
Thanks, if you feel confident you could add the feature using the console access by running:

--- End quote ---

Thanks for the code, at the moment I am looking to sell my Fluke so I'd rather not ruin it  :-/O  :-BROKE
If it does not sell, maybe I will. I still really hope it sells though, since I cannot justify having 2 handheld oscilloscopes.
zrq:
Have anyone looked into possibilites of bandwidth upgrades?
patpat:
CI/QI 10 is model name
CI/QI 11 is serial number
CI/QI 12 is serial number(same #11)
CI/QI 13 is board serial number

QI Query instrument 
CI Configure Instrument (this command requires entering into the "Maintenance" mode.
I've changed them w/o issue but I never measured the bandwidth.

if you have a 192C change the model to 199C and check the bandwidth..
The bandwidth could also be encoded somewhere else like SN or board SN

Best,
Pat
squadchannel:
hi patpat.
if you have a SG that can output up to 200MHz, I have something I would like you to test.

I found a QI25 command that I think is related to bandwidth, but it caused a problem with my THS. :palm:
if set it shorter than 40ns at 500mV and input more than 150MHz, the scope crashes.
I am trying to determine if this also occurs with patpat's THS (firmware problem), if there is a problem with my recovered calibration data, broke it with a QI25 command, or if there is a hardware failure. :scared:

Also attached is a scope meter tool that is under development.
Drag and drop dumpcal.cfg to SCMTool.exe. cal data will be dumped.
The serial port can be set in the cfg.

You can delete the serial number, and it would be helpful if you attach the dump data.

Others should not use it yet. >:D
uploading to xdevs etc. is also prohibited.

MOD: one hour later...
I found the cause of the crash.
It seems that the crash (low voltage?) occurs when the battery is not connected and only the adapter is used, possibly due to power consumption.
When the battery is connected, it works without any problem.

bug found. attached file replace.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod