Products > Test Equipment
FNIRSI-1013D AS MUCH USE AS A CHOCOLATE FIREGUARD.
Gannet:
Do you think this is it Peter?
Gnight
George
MrAl:
--- Quote from: pcprogrammer on November 24, 2022, 07:07:38 am ---
--- Quote from: MrAl on November 24, 2022, 06:42:13 am ---So i guess this is the same as the 1014D just in a different package?
--- End quote ---
Yes, but with a simple AWG, and the hardware user interface added to it. For the rest the same crappy front end, same FPGA, ADC's and MCU.
--- End quote ---
Well thank you for the info this has been very interesting.
Now do i read it right when i see that the ADC's being used in these scopes are only rated for 200MS/s and not 1GS/s as advertised?
200 megasamples per second VS advertised 1 gigasamples per second that is.
pcprogrammer:
--- Quote from: Gannet on November 24, 2022, 09:46:24 pm ---Do you think this is it Peter?
--- End quote ---
Hi George,
yes that is the right file, but in the command you types you forgot the "dd". You used "sudo if=......" instead of "sudo dd if=......"
--- Code: ---sudo dd if=fnirsi_1013d_fwb.bin of=/dev/sdb bs=1024 seek=8
--- End code ---
Try the copy and paste method I wrote about before :)
Good day,
Peter
pcprogrammer:
--- Quote from: MrAl on November 24, 2022, 09:57:45 pm ---Now do i read it right when i see that the ADC's being used in these scopes are only rated for 200MS/s and not 1GS/s as advertised?
200 megasamples per second VS advertised 1 gigasamples per second that is.
--- End quote ---
A single ADC is only rated for 100MSa/s, but with two ADC's in a single package you get 200MSa/s by using different clock phases for each ADC. (180 degree phase shift)
All the information about the scope and the reverse engineering process can be found in this thread https://www.eevblog.com/forum/testgear/fnirsi-1013d-100mhz-tablet-oscilloscope/
Gannet:
Well Peter, you're not gonna believe this! it's up and running. My firmware must have been trashed after all. When I switched on there was lots of relay clicking. I put my probe in and hey presto it seems fine. I do notice that there is a slight screen shimmer.
Also i see under the battery icon it says v0.005 is that revision or volts?
Do we now have the latest firmware fix installed ?
Couple of pics to show are attached. I don't know what all the bother was about (he he) I must hold the record for the slowest installation of your firmware.
Thanks, a big bunch Peter, you'll get your thanks in heaven.
Best regards
George
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version