| Products > Test Equipment |
| FNIRSI-1013D AS MUCH USE AS A CHOCOLATE FIREGUARD. |
| << < (18/18) |
| daemon17:
Thanks Peter for the help. I'd like to share exciting news. ;) I got everything Best regards, Alex |
| daemon17:
Hi Peter! How can I restore the original firmware from the saved files: * FNIRSI_1013D_full_flash_backup.bin, * FNIRSI_1013D_tp_config.bin, * FWB_FSI_1013.bin Would love to know about it ;) |
| pcprogrammer:
The flash can be restored if needed by using the full flash backup and a flash programmer like a CH341 programmer, because that file (FNIRSI_1013D_full_flash_backup.bin) is an exact copy of the flash chip on the board. (Either 2MB or 4MB) The FWB_FSI_1013.bin is a copy of just the firmware part of the flash, and has to be renamed (don't recall to what) and written to the SD card as a normal file. Rebooting the scope would then write this firmware to the flash chip. This only works in the original firmware! Also not very useful in your case since it is the same version as already there. The file FNIRSI_1013D_tp_config.bin is not really important. It is just a copy of the configuration in your scopes touch panel. I added that to the backup because there are different touch panels in circulation and I needed to get my hands on one that I messed up in one of my scopes :palm: To revert back to the original firmware you can delete the new firmware form the SD card, or stick another blank formatted SD card in the scope. |
| Navigation |
| Message Index |
| Previous page |