Products > Test Equipment

Fnirsi -TC3

<< < (19/20) > >>

UniSoft:
I drew the schematic of the device.
I did it without removing the components from the PCB, so errors are possible.

PS. If you will see any errors, please let me know, I can re-check.

indman:

--- Quote from: UniSoft on November 29, 2024, 08:21:26 am ---I drew the schematic of the device.
I did it without removing the components from the PCB, so errors are possible.
PS. If you will see any errors, please let me know, I can re-check.

--- End quote ---
You did a great job! :-+
So far I have only noticed this place, shown in the screenshot

UniSoft:

--- Quote from: indman on November 29, 2024, 12:06:25 pm ---So far I have only noticed this place, shown in the screenshot

--- End quote ---
Thanks,
Also, I forgot to draw the fuse F1 (PPTC)

Updated schematics, attached...

indman:
Sorry, I forgot to add, I thought that you yourself would guess to add GND pin2  :)

UniSoft:

--- Quote from: indman on November 29, 2024, 05:33:27 pm ---Sorry, I forgot to add, I thought that you yourself would guess to add GND pin2  :)

--- End quote ---
Updated...
I am more focused on the firmware.

PS: If anyone have any questions about firmware feel free to ask.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod