| Products > Test Equipment |
| Frequency Counter 2Ero Selection |
| (1/1) |
| ko4nrbs:
My counter works very well to monitor my old Heathkit HG-10 VFO but when powered down I have to always select 2Ero before it will start accurately displaying the frequency. Is there any way to permanently select 2Ero so I don't have to select it every time? Thank you, Bill https://usa.banggood.com/1Hz-50MHz-High-Sensitivity-Frequency-Meter-Counter-Measurement-Tester-Module-7V-9V-50mA-p-1662557.html?cur_warehouse=CN |
| PA0PBZ:
I have no idea what 2Ero means and it looks like I'm not the only one. |
| ko4nrbs:
It is one of the selections on the PCB via a push button. It's shown on this site at the end of the page. https://kc7zow.tripod.com/hamradio/id6.html Bill |
| AVGresponding:
Presumably it means "zero" and is to reset the counter? |
| electr_peter:
--- Quote from: AVGresponding on December 15, 2022, 07:47:27 pm ---Presumably it means "zero" and is to reset the counter? --- End quote --- Yes. OP meant "Zero" option displayed on 7-segment display. |
| Navigation |
| Message Index |